Het lijkt erop dat je winkelwagen momenteel leeg is
Pole & Rod Support
OCTBOX
Extendable Keepnet Arm and 5cm QF adaptor Designed to give the capability to fit keepnets 3 and 4 to the left and right of keepnets one and two. We recommend fitting two 30cm posts into the front of the extending keepnet frame and only extend the frame a few inches. The keepnets in this configuration will be on the front of the frame as apposed to inside and either side of ...
€33,00
OCTBOX
Schuift eenvoudig in het V-gedeelte op de stoel en wordt vastgezet met twee meegeleverde klinknagels.
€10,00
OCTBOX
MK20 Rod and Topkit Roost Light weight but ultra strong roost that can be set at numerous angles with the ability to hold both rods and top kits up to top 6 without any risk of it slipping. No requirement for an additional support , the all alloy construction has a disc pin locking system that ensures no matter how much you load on to the roost and what ever angle it cannot ...
€164,00
OCTBOX
Octbox Support – Roost Insert Set of 3 Fits into the rear rubber cone to fix top kits more securely To fit simply push into the rubber cone or tap in with a hammer on the cones you require for topkits Not required if your topkits are fitted with puller pungs that extend from the rear as apposed to the side.
€0,00
OCTBOX
Octbox Support – Feeder Arm MK19Fitted with two M8 sockets to allow feeder heads to be fitted on the end or at 90 degrees to the feeder armThe Octbox adjustable feeder can extend from 65cm up to a length of cm and can be setup in seconds at any angle.The feeder arm is supplied with either a 25mm or 36mm dia connector that is secured to the seatbox leg. The feeder arm is slid...
€74,00
OCTBOX
Octbox Extendable Extension Arm 25mm The Extendable Extension arm extends from 40cm to 70cm with round 25mm clamps on each end to fit on to any round 25mm leg system Extends 40cm to 70cm
€42,00
OCTBOX
23cm Extension Arm D25/D25mm Adaptors MK22 Slim Design 23cm Centre to Centre Arm designed to fit on 25mm Dia Round Legs and Posts
€28,00
OCTBOX
Feeder Arm Leg Adaptor D25/D36 Fits a spigot to the leg that the feeder arm slots on too.
€14,00
OCTBOX
De Octbox XL Pole Support is veel breder dan de eerdere modellen en is ontworpen om meer EVA-schuim om contact te hebben met de vaste hengel om het gemakkelijker te maken om de vaste hengel onder controle te houden bij windvlagen. Geleverd met twee telescopische poten die in de adapterstang worden bevestigd die in de voorkant van de voetplaat is ingebouwd.
€84,00
1 – 10 Product(en) van 10